diy aquaponics floating raft | New research on harmful emissions of 3d printing

diy aquaponics floating raft

New research was released about harmful particles in 3d printer fumes. Yes, inhaling molten plastics is not the best thing for your health. Who would have guessed?
In near future we will probably see some sort of regulation regarding 3d printing, starting from consumer warnings to control of 3d printer enclosures, ventilation and filtration in schools.


From the source article:

A new study in the journal Environmental Science & Technology by researchers at Illinois Institute of Technology and The University of Texas at Austin sheds more light on potentially harmful emissions from desktop FDM 3D printers. The researchers measured emissions of both ultrafine particles (UFPs) and volatile organic compounds (VOCs) from 5 commercially available polymer-extrusion 3D printers using up to 9 different filaments.

The researchers found that the individual VOCs emitted in the largest quantities included caprolactam from nylon-based and imitation wood and brick filaments (ranging from ~2 to ~180 g/min), styrene from acrylonitrile butadiene styrene (ABS) and high-impact polystyrene (HIPS) filaments (ranging from ~10 to ~110 g/min), and lactide from polylactic acid (PLA) filaments (ranging from ~4 to ~5 g/min). Styrene is classified as a "possible human carcinogen" by the International Agency for Research on Cancer (IARC classification group 2B). While caprolactam is classified as "probably not carcinogenic to humans," the California Office of Environmental Health Hazard Assessment (OEHHA) maintains low acute, 8-hour, and chronic reference exposure levels (RELs) of only 50, 7, and 2.2 g per cubic meters, respectively, all of which would likely be exceeded with just one of the higher emitting printers operating in a small office.

Source:

http://tech.slashdot.org/story/16/01/29/006242/desktop-3d-printers-shown-to-emit-hazardous-gases-and-particles

Detailed research paper:

http://pubs.acs.org/doi/abs/10.1021/acs.est.5b04983

.The last sentence from the research summary clearly states:

Results from a screening analysis of potential exposure to these products in a typical small office environment suggest caution should be used when operating many of the printer and filament combinations in poorly ventilated spaces or without the aid of combined gas and particle filtration systems.

Stay safe guys!

Do you find information about diy aquaponics floating raft are you looking for? If not, below may help you find more information about the diy aquaponics floating raft. Thank you for visiting, have a great day.

Related Posts by Categories